The serial number can be found on a decal attached to the weight rack see the front cover of this manual. WEBE Refer to the drawings below to identify small parts used in assembly. The number in parentheses below each drawing is the key number of the part, from the Part List in the center of this manual.
The number following the key number is the quantity needed for assembly. Page 6: Assembly Assembly Before beginning assembly, carefully read the following information and instructions: Make Things Easier for Yourself! This manual is designed to ensure that the weight rack can be assembled successfully by anyone.
By setting aside plenty of time, and by deciding to make the task enjoyable, assembly will go smoothly. Page 7 3. Make sure the Uprights are oriented exactly as shown. Do not tighten the Nylon Locknuts yet. Page 8 6. Press a 38mm Bushing 29 into each end of the Right Weight Glider Do not tighten the Screw yet. Make sure the Right Weight Glider is oriented exactly as shown. Page 9 Page 10 Slide the bracket on the Pulley Bar into the top of the Rear Upright 2.
Page 11 Tighten an M10 Nylon Locknut 11 onto the Bolt. Route the High Cable 13 around a Pulley 5 as shown. The weight rack can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. Raise or lower the Safety Spotters to new positions and pivot the hooks back into the slots in the Uprights. As you progressively increase the intensity of your exercise, your muscles will continual- ly adapt and grow. Page 15 Make sure to rest for a short period of time after each set.
Assembly requires the following tools not This manual is designed to ensure that the included : weight rack can be assembled successfully by Page 7 3. Make sure the Uprights are oriented exactly as shown. Do not tighten the Nylon Locknuts yet. Page 8 6. Press a 38mm Bushing 29 into each end of the Right Weight Glider Do not tighten the Screw yet. Make sure the Right Weight Glider is oriented exactly as shown. Page 9 Page 10 Slide the bracket on the Pulley Bar into the top of the Rear Upright 2.
Page 11 Tighten an M10 Nylon Locknut 11 onto the Bolt. Route the High Cable 13 around a Pulley 5 as shown. The weight rack can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. Raise or lower the Safety Spotters to new positions and pivot the hooks back into the slots in the Uprights. Page 15 Make sure to rest for a short period of time after each each stretch gradually and go only as far as you can set.
The ideal resting periods are: without strain. Page 18 Part List—Model No. Description Key No. Page 19 Exploded Drawing—Model No. This manual is also suitable for: Webe Print page 1 Print document 19 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals?
0コメント